Output shaft shim size

[Fotog]

I just measured some that I have, from RD Enterprises.
25.4 I.D., 35 O.D.
Vince

[jbcollier]

Spot on.

It's a 1" ID and an 1 3/8" OD

[califkid_66]

they are not so hard to find to bad it’s not the same for roll pins

[Bryan Boyle]

they are not so hard to find to bad it’s not the same for roll pins

outer is 7mm x 35mm
inner is 4mm x 35mm

outer placed with closed end towards transaxle, inner opposite.

[califkid_66]

i have a s2 federal so in imperial it’s the dimensions JB wrote
what do mean by outer and inner ?
the only shims i knew about were the one close to the transmission to adjust so it doesn’t move when  roll pins are put in
am i missing something

[SilverBeast]

i have a s2 federal so in imperial it’s the dimensions JB wrote
what do mean by outer and inner ?
the only shims i knew about were the one close to the transmission to adjust so it doesn’t move when  roll pins are put in
am i missing something

I think Brian was talking about the roll pins, not the shins, in response to calfkids comment above

[califkid_66]

ok thanks for clarifying i was a bit confused
makes sense so now we have all the measurements we need!!

[RafM]

The 37mm o/d - 26mm i/d shims I ordered have arrived, they are a perfect fit.

[jbcollier]

Good news.