Brake lights switch.

[BillsLotus]

Converting my brake Master Cylinder to a 5/8 Tilton. Need some help. Where is the brake light connected to the pedal?

[jbcollier]

The brake light switch is in the tee by the RH radius arm attachment point to the chassis.

[jbcollier]

PS: Might be LH side on a TC with boosters.

[BDA]

On my TCS, it is on the top of the frame “leg” on the left near the battery. It might be handy to note that the threads are 3/8 - 24 not 1/8 NPT like many are.

[SilverBeast]

As you have probably gathered its not connected to the pedal,  it's a pressure activated switch connected to the brake lines in the rear engine compartment.

[BillsLotus]

As you have probably gathered its not connected to the pedal,  it's a pressure activated switch connected to the brake lines in the rear engine compartment.

.

Thanks.

[BillsLotus]

Thanks for all the brake light info. Never would have found it without you guys advice.

[BillsLotus]

The brake light switch is in the tee by the RH radius arm attachment point to the chassis.

Thanks

[rjbaren]

By the way, I have done that same conversion and removed both boosters and I like the pedal.  I never drove the car with the power brakes so I can't compare.

[BillsLotus]

The brake light switch is in the tee by the RH radius arm attachment point to the chassis.

Thanks

[BillsLotus]

On my TCS, it is on the top of the frame “leg” on the left near the battery. It might be handy to note that the threads are 3/8 - 24 not 1/8 NPT like many are.

Thanks